Harry Montgomery
Member
Hey guys my name is Harry Montgomery and I have a 88 gt that I am about to swap a 03/04 motor into. I also have a 96 cobra parts car that I am going to be installing the cobra brakes as well as the cobra rearend...I am at a cross road before I start. My buddy has a wrecked 03 cobra low miles that I can get the dash, console, door panels and that kind of stuff. He said if I pulled the dash I could have it and the harness behind. I am already getting the 03 computer as well as the engine harness and cluster. Is that all the wiring I would need just the engine harness and the dash harness or will I need the body harness as well to complete the swap. As of now I'm going to pick up a 3650 tranny because the t45s I have laying around from other 96-98 cobras will not work with the newer cluster. Trying to get my ducks in a row before I get deep into the project. I am in the middle of building the motor I have a 98 cobra teksid block with Kellogg crank and the svt manley h beams all arp hardware....still tracking down all the swap parts have a big list but still need more...here is what I have so far....(03 dual fuel pump setup, blower, metco 4lb lower, engine pulley set up, heat exchanger and lines with intercooler pump, 03 39lb injectors, fuel rail, mass air meter with sensor for 39lb, intercooler tank and within the next few days have the ecu, engine harness, and dash harness) Long process but will upload pictures as I progress in the build...any tips would help greatly