1. Hello there guest and Welcome to Modular Fox Mustangs home of the 2V, 3V, 4V, Coyote Modular Mustang Conversion Information Website!
    To gain full access you must Register. Registration is free and it takes only a few moments to complete.
    Already a member? Login here then!

    Dismiss Notice

96 cobra swap to foxbody turn signal issues.

Discussion in 'Electrical Wiring' started by benstein IBC, Dec 25, 2018.

  1. benstein IBC

    benstein IBC Active Member

    Messages:
    33
    Likes Received:
    1
    Trophy Points:
    28
    i did a 96 cobra swap to a foxbody.
    i used the vobra complete harness. only thing left that couldnt be figured out was the turn signals. and windshield wipers, any clue on how to do it?
     
  2. Bill

    Bill Well-Known Member Staff Member Donator

    Messages:
    1,419
    Likes Received:
    245
    Trophy Points:
    93
    Since you used the complete harness, what kinds of problems are you having. I'm not an electrical guy, but might be able to help.
     
  3. benstein IBC

    benstein IBC Active Member

    Messages:
    33
    Likes Received:
    1
    Trophy Points:
    28
    i pretty much got the car tocrun, have headlights and brake lights. but cant figure oit the turn signals and high beams
     
  4. Bill

    Bill Well-Known Member Staff Member Donator

    Messages:
    1,419
    Likes Received:
    245
    Trophy Points:
    93
    What have you tried so far with the turn signals. I've had turn signal issues that turned out to be several problems. I had a bad plug that, even though it was fully plugged in, wasn't allowing proper contact due to the crimp on the wire. I had a switch that only worked when it wanted to. That one sucked to find.
     

Share This Page