Is that a fox body sway bar or a new edge sway bar?
-
Hello there guest and Welcome to Modular Fox Mustangs home of the 2V, 3V, 4V, Coyote Modular Mustang Conversion Information Website!
To gain full access you must Register. Registration is free and it takes only a few moments to complete.
Already a member? Login here then!
Foxbody 4.6 Dohc Swap
- Thread starter ponyboy89lx
- Start date
Is that a fox body sway bar or a new edge sway bar?
its from a 01-04 GT car.
Did it bolt right up for you? Which mounting brackets did you use?
Speedtospare
Well-Known Member
I'm looking to put a sway bar on for street duty. Might have some used aftermakret Steeda ones to try.
no it was a little funky it may not work or it might work great will have to drive it to find out. I figure a man could redrill the holes wider and it would work great, i used the factory brackets on the 01 up bar and the factory mount holes on the fox.
Well i havent been able to do anything to the car lately, been busy trying to get alot of stuff done. As soon as i get back on it i will post up some pics.
Was re-reading your thread here again. Are you running a the stock computer with this dizzy setup? How hard was the wiring?
If memory serves, I think it's the stock 5.0 EEC that he is running.
Speedtospare
Well-Known Member
Only issue with running the EEC-IV is that you can only runa base timing. The newer computer allowe you to adjust timing through the entire RPM band.
yes i am planning on running the mass air EEC ( A9L ) the wiring is a stock 5.0 harness that was very easy to mod, had to change a couple of plugs out and extend some wires but it was rather simple. When i get the computer i suspect i will have some issues, hopefully nothing major though. Im not gonna run any power adders such as juice or turbo, so the base timing should be just fine for me.
got some front skins the other day for free, had a ton of tread left. Anyways gonna try to get this thing fired up here in the next couple days.
Nice! I gotta talk you in to doing the cobra manifold swap! You're leaving 20-30hp on the table.
Oh yeah trust me i want one BAD but hate to pay a shit load of money for one, im sure if i will be patient i will find one thats a reasonable price, as of now the headers im running should make up the loss in HP for the intake but i will find one eventually.
Speedtospare
Well-Known Member
I see Mach 1 intakes go for 350-400 complete on ebay. They flow more than the cobra intakes. I paid 400 for mine and it was brand new.
I may be wrong but arent mach heads " C " heads. Im running " B" heads
yeah i thought so lol. I will evenyually get get a cobra intake but its not gonna keep it from running, i get one later lol
Speedtospare
Well-Known Member
Sorry i missed the b-head part. I have an extra set of c heads
i will stick with what i got for now lol but thanks for offer
picked me up new MSD coil and cap and rotor button today, ECU a battery and some cables should get me really close