• Hello there guest and Welcome to Modular Fox Mustangs home of the 2V, 3V, 4V, Coyote Modular Mustang Conversion Information Website!
    To gain full access you must Register. Registration is free and it takes only a few moments to complete.
    Already a member? Login here then!

DFW 88 Notch

ssowell

Member
Howdy all, my name is Shelby (I know :cool:) and I live in Arlington, TX. I've been trying to figure out what to do with my Fox as of recently. I rebuilt a 306ci for it then stroked it to a 331. I'm just over old school efi with pushrod. I've got a wrecked 2000 gt that I was going to just sell the motor. I'm thinking about doing a mod swap with the 2v and t45 to try to get out as budgeted as possible for now. Once I have a complete swap done I'll start saving up for my 4v/t56 and all that jazz. A couple of other ideas I was thinking and researching is a LS1 swap, but that takes the beauty out of Ford, and also expensive.

The reason for registering is I don't even know where to start, my fox is "stripped" as of yesterday and about to go back home (Sweetwater) to get some body work and paint done. On the trip back I'll be bringing the 2000 GT to start disassembly of that whole car. I need to know the basics to doing the swap with the best budgeting possible. This is gonna be a daily driver once complete, so that's another reason I need to do my research.

Thanks! and here's a big of my baby (w/ a 306ci in it)
253879_2070014437565_538096_n.jpg
 

whiteponygt

Well-Known Member
welcome dfw88 everyone on here is very help full but what ur gonna have to do is start a post in a different section. i made the same mistake post it under 87-1993 mod conversion.Im just not starting the swap and you will need a lot of things from the car cross memeber wiring harness, hydroboost master cyclinder. you will need the factory transmission cross member.the transmission,and dash is you wanna go that route
 
Top