-
Hello there guest and Welcome to Modular Fox Mustangs home of the 2V, 3V, 4V, Coyote Modular Mustang Conversion Information Website!
To gain full access you must Register. Registration is free and it takes only a few moments to complete.
Already a member? Login here then!
Latest activity
-
Any details on the 1/4 wave pipes? Sounds interesting! -
Oboy, lots of details! When i put together the new exhaust system, i had the worst "drone" between 1600-2100rpm. I recorded it on my...
-
Bill replied to the thread Teksid 2V Tech Article (Must Read).The pipes look interesting. I hadn't considered building in a counter-resonance to defeat a specific drone frequency. I've used...
-
KKmax replied to the thread Teksid 2V Tech Article (Must Read).Oboy, lots of details! When i put together the new exhaust system, i had the worst "drone" between 1600-2100rpm. I recorded it on my...
-
-
Mmassacre replied to the thread Teksid 2V Tech Article (Must Read).Any details on the 1/4 wave pipes? Sounds interesting!
-
MAnother 60km drive today, load on/load off, varied RPM, a couple pulls to 4000RPM in 1st, 2nd, 3rd. Ok, maybe 3 pulls. The engine...
-
MAgreed, i've been cleaning and rerouting cables (and hoses) whenever the opportunity presents itself. The engine now has about 1100km...
-
Another 60km drive today, load on/load off, varied RPM, a couple pulls to 4000RPM in 1st, 2nd, 3rd. Ok, maybe 3 pulls. The engine...
-
KKmax replied to the thread Teksid 2V Tech Article (Must Read).Another 60km drive today, load on/load off, varied RPM, a couple pulls to 4000RPM in 1st, 2nd, 3rd. Ok, maybe 3 pulls. The engine...
-
-
Agreed, i've been cleaning and rerouting cables (and hoses) whenever the opportunity presents itself. The engine now has about 1100km...
-
KKmax replied to the thread Teksid 2V Tech Article (Must Read).Agreed, i've been cleaning and rerouting cables (and hoses) whenever the opportunity presents itself. The engine now has about 1100km...
-
-
Waiting on some new sensors
-
Mmassacre replied to the thread Progress on my Zephyr.Waiting on some new sensors
-
Mkeep us up to date on your progress with it. At $1500 +/-, it is a very affordable option that I have drooled over a couple of times.
-
MIt does look nice now. I'm a big proponent of cleaning and rewrapping wire looms. I have found several issues in advance that way (and...
