Hello there guest and Welcome to Modular Fox Mustangs home of the 2V, 3V, 4V, Coyote Modular Mustang Conversion Information Website!
To gain full access you must Register. Registration is free and it takes only a few moments to complete.
Already a member? Login here then!
Yes. Depending on how you position the dash, you'll have to clip the inside pull release handle just enough to clear the corner of the dash. I have seen guys heat and bend them instead of cutting them. I haven't tried that.
I have learned a couple of things the hard way about putting the dash in and getting it to look right. First, if you plan to use the SN95 console, put it in first. This lines up on the e-brake and shifter and gives you a reference point. Second, if you can afford to take out the windshield, that also makes the final trim much easier. Neither is an absolute necessity. They just make it easier.
That's great advice, Bill. Putting in the console first makes sense. I'm a bit concerned about removing the windshield. I know it would really make things easier, though. Anyways, I have time to think about it.