• Hello there guest and Welcome to Modular Fox Mustangs home of the 2V, 3V, 4V, Coyote Modular Mustang Conversion Information Website!
    To gain full access you must Register. Registration is free and it takes only a few moments to complete.
    Already a member? Login here then!

The Detail Zone

Status
Not open for further replies.

modularf

Well-Known Member
Ok, we began the wiring up the car and would like to say that the this kit from The Detail Zone is awesome.
It beats trying to figure out all the wiring from this rats nest..:)
DSC_0236.jpg

There are 23 individually wraped bags labeled from Bag #64 - Bag #83
DSC_0110.jpg

The kit is so detailed that it can be installed by a non mechically incline person. Each individually wrapped bag comes with all connectors attached and all you have to do his connect it were it tell you and then to the TELORVEK Panel. (TELORVEK Panel image below)

DSC_0193.jpg

Pictures of the Injectors connectors and TPS Sensor wired up.
DSC_0189.jpg

Below is an example from the instruction booklet that comes with the kit.
[EXAMPLE: Bag #62 IGNITION CONTROL MODULE CONNECTION: The ICM requires some of the wires to be shilded from any electrical interference, that is why six of the wires in the connector are wrapped]
DSC_0205.jpg

We found a location for the ICM and run all the wires
DSC_0211.jpg
DSC_0214.jpg

I will post more pics once completed...
 
Status
Not open for further replies.
Top